Vacuum Sewage Truck Operation Instructions 1. Maintain the proper rotation speed of the vacuum pump. If the speed of the vacuum pump is too high, the rotor will intensify the heat generation. If the rotation speed is too low, the engine will knock, the components will cause additional shocks, affect the service life, and the appropriate working speed. The maximum adjustment position of the throttle valve is adjusted in advance. . 2. Sewage suction trucks turn tanks on uncongested roads: Turning tanks on sloped roads will not only cause distortion and distortion of various components, but also may cause rollover accidents. 3. When the sewage suction truck turns the tank, open the rear door and window firstly. Before the dumping tank dumps the mud, open the rear door cover. Remember to close the door and turn the tank. There is danger of overturning due to gravity shift. 4. When the clutch oil pump power take-off box and the vacuum pump take the power box, the engine idles, and fully steps on the clutch pedal, and slowly lifts the clutch pedal when clutching. 5. Pay special attention when driving the car: Take the lever control lever in the middle position. 6. Do not use this vehicle to inhale and transport waste oil and hazardous materials. 7. When entering the bottom of the tank in the state of raising the sludge tank, you must use the support to plan the safety stop. 8. When transporting sewage, the rear door leaf clamp must be used. Because there is no anti-wave board in the tank and the center of gravity is high, the vehicle must be running at medium speed and slow speed. No sharp turn and sudden braking are allowed. Xigong Chusheng (Hubei) Special Automobile Manufacturing Co., Ltd. Manufacturers selling hotline, the company's official website:, welcome customers to visit our company Electrodes Cutting Blades,Li-Ion Battery Seprarator Cutter,Li-Ion Battery Membrane Cutter,Pole Piece Slicing Blade Guangdong Rixin Precision Technology Co., Ltd. , https://www.nissontooling.com